Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I created below model. it was configured basically. now, i want to route a packet from Com 1 to Com 4 go through MSwitch 2. It means the path: Com 1 -> MSwitch 0 -> MSwitch 2 -> MSwitch 1 -> Com 4. Now, I have configured RIP method to all MSwitch and...
I'm a newbie in this topic. My duty is separate a network into 30 subnets( without using vlan). My model is below. My needs is:
- Every L2 Switch belong to a constant and sole ip range and when i connect it to any L3 Switch then it still works with o...
Can i create smaller VLANs from a VLAN? and How to do that?
Ex: I use a multiple switch 1 to create 2 VLAN (vlan1 and vlan2) and assign 1 ip address to each VLAN (vlan1: 1.1.1.1/24, vlan2: 1.1.2.1.1/24). as demanding, I want to segment vlan2 into 10 ...
@Joseph W. Doherty my knowledge about Proxy is so vague. according to my knowledge, Proxy must have 2 IP at least (input and output). I want clients to connect to Peer0 via Proxy that have output IP is 1.1.1.x or 1.1.2.x
@Joseph W. Doherty Peer0 is a external network. i want Clients to be connected to this network via a Proxy server. and Output IP of Proxy Ssrver will be kind of 1.1.1.x or 1.1.2.x as the Server's IP. Where should i put that Proxy server at? Sorry my ...
@Joseph W. Doherty i created a model. Clients, Server and Peer0 are connected to each other(ping ok). now i want Clients to use a Proxy server to change their IP into Server's IP. ex: 1.1.3.x -> 1.1.1.x.
Where should i set up Proxy server?
