Hay Guys,
currently i setup my first Cisco switch and have a Problem.
I go inside in the Cisco switch, with the following:
-> Buissnes Network (untagged)
-> Guest Network with VLAN40 tagged
on with way i can route the VLAN 40 Tagged Data from my ...
Yes, its the Gateway on the VLAN with Tag 40 with IP 192.168.2.1 and also on the untagged VLAN with 192.168.178.1The VLAN3 is in this case only the Configuration Slot, if you look in the rigth Table, you see that te packages are Tagged with 40, and i...
Hay,
so the Router (second Image) has on VLAN3 the Config for the Tagged VLAN. The System Works fine with an Unmanaged Netgear GS108 Switch. Only the Cisco switch dont pass the Data!
The Wireless Config from this Picture is only for the Integrate...
Hay,
on Port 11 i have acces to the Managment Interface of the Accesspoint in the untagged Network (192.168.178.10), but no Access to the Tagged network (VLAN40) if i connect a "unmanaged" switch betwen the Router and the Accespoint, all works fine...
So now i Try the Config, i got the Buissnes Net (untagged) on all required Ports. Also i Configure Port 48 for direct Access to the Guest Network VLAN40.
But my Ports like 11 dont can handle Data on VLAN40, i get acces over the untagged Native VLAN ...
Hay,
now i think i understand it better!
Is it required to set all Ports to Native VLAN 10 to have on all other Ports the untagged incommig IP Range 192.168.178.xxxx?
