Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is my dilema:I have a Cisco 7507 with two slots (2 and 3).hw-module slot 2 need to be replaced.After couple days, I received a new hw-module and put on slot 2. I had the startup-config from a CUT/PASTE on notepad and did a config t and paste the...
Hello,On Cat4006 I did: show cam dynamic 2/13.I have the mac-address of a machine connected to that port. Now, I want to find out what is its IPADDRESS? I am trying to find out what IP is using the port 2/3, and the connected device is not a cisco pr...
Hello,
I am trying to setup DMP (Duo device Management Portal) on Windows server 2019 running IIS aspx. Do you have the details instructions on anything that can help?
That could've been nice, but I think or maybe the RSP on slot 3 was not configured. I little bit confused. what service single-slot-reload-enable realy means?--Alex
Thank you very much, it works. I went to another core switch downstream and map most of the mac-addresses to ipaddresses, except one that I don't know why. I know the vendor of that NIC or device, Digital Equipment and believe that whatever is it is,...
Hello Georg,what I was saying that the device connected to the 4006 port 2/13 is not a cisco device. It is a Digital Equipment(an old network card '08002B'). From the 4006,I couldn't trace the mac-addres to ipaddress. I had to access the 6509 and try...
