Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,I seek your help. I have issues with frequent clients disconnections from my wifi network. We use Cisco WLC 5520 and LAPs (AIR-AP2802I-E-K9). What I see from WLC Logs:SpoilerDot1x_NW_MsgTask_0: Dec 21 09:15:01.785: %DOT1X-3-ABORT_AUTH: [PA...
Hello Team,I have here curious case, I am seeing local routes in my routing table which is not configured on my router. See below:SpoilerL 10.51.38.129/32 is directly connected, GigabitEthernet0/0/2.950L 10.51.38.150/32 is directly connected, Gigabit...
Hello Team, I am planning to replace old End of Support IPSEC router with new ASR 1001-X. This router has included IOS as below: Cisco IOS XE Software, Version 16.06.03
Cisco IOS Software [Everest], ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M),...
Hello Team, I am experiencing the service instability on my network with ISR4431/K9. From monitoring tool I see the CPU utilization goes to 99perc, my logs disappear, then BGP goes down, then UP. Router is not rebooting. This is happening also during...
Hello Team,I would like to better understand of behavior of my QoS. I have configured class with priority, and then with police. Lower classes are configured with "bandwidth remaining percent" command.policy-map TRAFFIC-OUT-Gi0/0.7
class OUT-VOICE
...
Hello Team,thank You for your help in this matter.After modifying EAP timeouts there were still disconnections. We made troubleshooting session with Cisco TAC and they found we use bad version of wifi adapter (intel). Windows didnt recognize new avai...
Hello Team,I have opened TAC with Cisco, they have recommended to do a debug: SpoilerDebug client <MAC of client1> <MAC of client2> <MAC of client3> <….10>Debug dhcp message enable Debug dhcp packet enable Debug web-auth redirect enable mac <MAC of c...
Thank You for your answers, I have fixed it - by workaround. I have moved admin interface to redundant router, and now on new router it is working good, I dont see any non-existing IP addresses in my routing table.But I didnt find out what caused the...
Hello,disconnecting issues are since we have WLC, but there were not so frequent as today. Network between WLC and Radius is physical, MPLS. I will try to change Fast Transition settings.Thanks a lot.
