Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm replacing my old cisco wifi AP's with MR 44. the old cisco AP's wifi clients get their IP address form the DHCP. I notice we have some DHCP options in the scope for wifi clients to get assigned a specific subnet. I have plugged 12 Meraki AP an...
when you power on a switch for the first time it asks if you want to configure the switch if you select no you don't get prompted again. Is there a command to launch the setup mode again? How to restart the initial configuration setup on a cisco swi...
I'm upgrading 2960 switches with 9200L switches, can I copy the config from the old 2960 switch and paste the config to the new 2900L switch? would that work?
I have a few vlan with status down and line protocol down. when I ping certain IP addresses from workstations I can't.when I traceroute from DHCP server I get a bounce back from two routers. when i enter the sh ip int br I see the vlan status as do...
I'm trying to enable OSPF on a switch gigabit port in order to advertise networks. I've have added the port in question on to the VLAN that is needed. the vlan it self is set to passive, but I don't want to disable passive on the vlan just on the on...
I did notice the AireOS controllers are pointing to my internal DHCP server. when I run ipconfig on a client connected to the old AP's it states the DCHP server as 1.1.1.1 which is associated with the AP controller.now I have configured the port on ...
@Ryan25 , thank you for your suggestion for this. I check this option and it allows for access to other networks in the WLAN outside my on-prem networks but using the Meraki AP assigned NAT mode which assigns IP addresses to the client in the 10.0.0...
