- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-19-2022 07:45 AM
when you power on a switch for the first time it asks if you want to configure the switch if you select no you don't get prompted again. Is there a command to launch the setup mode again?
How to restart the initial configuration setup on a cisco switch
Solved! Go to Solution.
- Labels:
-
Catalyst 9000
-
LAN Switching
-
Other Switches
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-19-2022 08:20 AM
Hello,
Switch>en
Switch#setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-19-2022 08:20 AM
Hello,
Switch>en
Switch#setup
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-19-2022 09:00 AM
Thank You for the quick response, much appreciated.
