Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
first some background. Switch had a emergency-installation of version 3.6.6 after a failed upgrade from version 3.2.2.
In the process of doing the upgrade, the flash was supposedly erased.
When I dir flash:, flash-1, or flash-2, it all seems to jive...
I am getting this loop after attempting a package update to the recommended release for our 3850 48T-S
How do I proceed when it never gets to a prompt?
Getting rest of imageReading full image into memory...Check base package header ...: done = 16384G...
A couple of clues from my own experience. ymmv
When upgrading software, from really old software, you will have to regenerate RSA info otherwise you will get SSL errors. If you do not have a lot of preexisting setup, this can be cleaned up by doin...
Yes,
however when I ran "?" at the "switch:" prompt, "enable" was shown as an option but would not run.
after doing several versions of erase, and setups, I was able to get a clean running Stack again.
no enable at switch: prompt.
earlier when I ra...
Also this: I saw that there was some virtual services options under the ROMMON mode (OpenFlow etc.) I wanted to check out. However, I cannot seem to get into privileged switch mode.
switch: versionCAT3K_CAA Boot Loader (CAT3K_CAA-HBOOT-M) Version ...
more info:
After running software clean, I get a "no files to clean" message.
Copying files from USB to flash: it reports files exist. Copying from flash: back to USB it says the same files do not exist. Copying a new file to flash (in any locatio...
so I tried various things.
I tried copying the new software to flash: says that it already exists, but does not show up in dir flash:
dir flash-1: nor dir flash-2: it is as if there is a hidden flash file somewhere else.
copying packages.conf.02...
