Hello Team,I am doing POC for customer with below operating IOS code on Cisco 6500 s2t54-advipservicesk9-mz.SPA.151-1.SY.binreceiver receives a delay in receiving the multicast stream.Does the above operating system support PIM Graft messages ( recei...
Hello Everyone, I am working on PIM Dense ( refer to attached topology ) The source is directly connected to R5 and receiver is connected to R6. and the topology is running OSPF with area 0. Unicast routing is fine. The receiver is configured with " ...
Hi All,
I need your help regarding destination NAT
We've two locations A & B.
From A to B there is IPSEC tunnel through traffic is being transverse.
There is website hosted on B ( which is accessible from Internet ) , however internal user ...
Hi Jon, Thank you for the response. The Topology I shared is as per our design. For reference, I have included "show run" and " mroute" from all devices involved. The problem is, as soon as the customer starts the multicast, it is first received on ...
Adding more on to this,When there is no traffic , muticast traceroute follow R6,S4,S3,S2,S1,R5 and source.However , when I send traffic from Source, the mutlicast route follow Receiver, R6,R5,SourceIt is mutliaccess ethernet network, where all interf...
Hi Paul, I run the requested commands on R6, R5 ( where Source is connected ), and S1, But I couldn't find something fishy. R6#traceroute 192.168.170.20 numericType escape sequence to abort.Tracing the route to 192.168.170.20VRF info: (vrf in name/...
Just to add here Network 10.1.1.1 & 125.1.1.1 both reside at B location ( remote ) and 192.168.1.0/24 is reside at source side ( location A) So I need to configure at Location A
