Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,All leds of my AP turned amber. this means "Boot failure" according to this document: http://www.cisco.com/en/US/products/hw/wireless/ps430/products_installation_guide_chapter09186a00801cfb52.htmlBut how can I get through it?
Hello,I'm trying to tests some functionnalities of the WLSE.Is there a way to combine many alarms in order to generate a fault?For example I want to generate a (and only one) fault IF the CPU Utilization moves above 50% (value of the threshold I choo...
Hi,Can anyone tell me what do these options mean? In fact I have a problem when reloading my WLSE. In I choose CiscoBreR I get this message :"Looking for verskmod: failed to exec /sbin/modprobe -s -k char-major-254, errno= 2ion infoinsmod: flashdrv3....
Hi,I tried to upgrade from 2.5 to 2.7 and then to 2.7.1, and I can't connect to WLSE anymore with web browser. In fact, when i'm going to : http://wlse_ip_address:1741, i have the page where i can enter my login/password (which work with telnet as w...
Ok I had my problem (3 leds turning to red when powering up the AP) after trying to upgrade VxWorks to IOS.I looked at the URLs you showed me but the thing is that I can't connect to the AP by console port. It doesn't show anything.So how can I recov...
hi, I have my AP 1200 having all leds turned amber. I tried your method... But I can't even console or ping my AP when I'm powering it.Please, help!Best regards,Michel
