Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm setting up a simple homelab as I learn CCNA using a 3560G-48P. I have setup a vlan 20 and put 16 ports on it. The host is my PS4 since its easy to see network info. I setup a dhcp pool of 10.0.5.0 /24 and assigned it to vlan 20. on t...
I've 'wr erase' a few times but I keep getting the same result. The last time I created VLAN2 in the web portal and it no longer is available to connect to and drops off the IP scanner. Any ideas on what I'm missing?
I'm deep in the CCNA Route Sw...
It's
ISP Router (NVG468MQ) -> Cisco 3560G -> PS4
ISP Router (NVG468MQ) -> Cisco 3560G -> Cisco 3560G
So, after messing with this I got it working and connected to the internet in the 10.0.2.0 subnet. Afterwards I took out each thing I tried and ...
Hi Ric,
Sorry for the delay and thanks for your help. I tried what you said and a few more things with no luck. I just wr erased the AP and started over and have decided to wait a while for my courses to find out what was happening.
Thanks agai...
Ok thanks for your help on this btw.
Yes the AP is connected to my 3650G POE. The port on the switch was set to dynamic auto. I did:
conf t
int gi0/6
switchport trunk native vlan 2
and didn't get the AP (192.168.1.3) back on the IP scanner. I tr...
So I have it setup where I'm connected to 192.168.1.3 via either SSH, Telnet, or Webgui. And the moment I make VLAN 2(just create it not even do anything with it) I lose connection on every avenue leaving me only to console in. And yes I can consol...