Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We purchased a pair of Firepower 2110's with the intent to configure them as ASA using Appliance mode. During installation we found that only certain configuration settings can be changed from FXOS, such as enabling interfaces, and speed duplex. The...
My team is working to deploy a pair of FPR2110-ASA-K9 in an active/standy, single mode configuration and we want to manage via the ASA. During initial setup we found that certain configurations are only available using FXOS, such as enabling interfac...
Hello,The 'show fxos mode' command is not recognized. Based on another comment this may to be due to the code level. We're running 9.12.x and Appliance mode appears to have been introduced starting at 9.13 so we will attempt a code upgrade.Thank you
