We purchased a pair of Firepower 2110's with the intent to configure them as ASA using Appliance mode. During installation we found that only certain configuration settings can be changed from FXOS, such as enabling interfaces, and speed duplex.
The documentation states that these firewalls come default in appliance mode and that all configurations should be available from ASA, this is not the case here and would appear we're running in platform mode.
The 'fxos' and 'show fxos' commands are not available, the ASA does not recognize these as valid commands so there is no option to switch between appliance and platform mode, nor confirm which mode we're currently operating.
Code is: cisco-asa-fp2k.9.12.3.12.SPA
Any help with this would be appreciated.
