Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I was wondering if it's possible to have a CE router send routes between customer routers in the same VLAN? I have a situation where I have a customer with two routers that hookup to my CE switch. I'm receiving routes from both customer rou...
Hello. I have a situation where I got two paths to get to a destination. Router A can get to subnet C either through my Telco's onsite router (Router A->telco router->Router C)or through a secondary link that travels from Router A-> Router B->diffe...
Hello. Does anyone know if there's a maximum file size supported on the 256 MB compact flash cards that go with the ISR routers?I've been trying to upload some newer code on my routers and whenever the transfer hits 33,546,240 bytes the transfer sto...
Hello. The documentation that I've read on HA IPSec utilizing HSRP shows a headend site utilizing two routers running HSRP and the branch office running one router.I was wondering if you can run IPSec in HA mode utilzing HSRP at both the headend and...
Hello. I was wondering if anyone has any experience with setting up an IPSec connection in transport mode?I have a situation where I need the original source and destination address to be preserved. I would be running this IPSec connection within a...
Hi Paresh. Here's the config from the CE router...ip vrf vrf_168 rd 192.168.53.2:1interface Vlan167 ip vrf forwarding vrf_168 ip address 192.168.53.35 255.255.255.224 no ip redirects no ip unreachables ip ospf authentication ip ospf authentication-k...
Hi there,In this case when I had the OSPF cost of 100 on the vlan 162 interface I had a situation where a route (192.168.33.0/24) learned from vlan 162 would be intra-area and a cost of 100. This same route learned from vlan 168 would be inter-area ...
That did the trick Paresh. It's going through the right interface now!I was wondering if you could tell me how come the cost of the interface would have an effect in this situation? I'm new to OSPF and I thought intra-area routes would be picked ov...
Hi Paresh,No problem. Here's the show commands...show ip os int vlan 168 Vlan168 is up, line protocol is up Internet Address 192.168.19.5/24, Area 0 Process ID 1, Router ID 172.27.161.1, Network Type BROADCAST, Cost: 1 Transmit Delay is 1...
