Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we are managing multiple office which ask for Public IPs (if required by them). we have pool of multiple public IP addresses and we give them the IP from the pool to use them on their router on their end. we have 2 vlans setup on our layer 3 switc...
Hi we have network with no vlan setup. I have attached a simple pic. Every thing is running on default vlan. Now we have a requirement for vlan to separate a network. I will have to create sub interfaces on lan port of router. My Question is:Can i a...
Hi, I am trying to remove static nat but getting error that static nat is in use. I don't wan to clear complete nat trans*. Is there any way I can remove nat entries for specific lan ip? following are few entries I am lookingtcp 206.x.x.x:3389 192.16...
HiCan I use quick VPN client on win 10 to connect vpn from RV 110 w vpn firewall? I have downloaded the available client from cisco but its just stuck on "connecting". Any advise on it?
Hi,We have cisco 5505 with device manager version 6.4I am trying to run nat (inside,outside) cli commands and its not taking in. Do we have incompatibility with those commands on this version? Just trying to configure l2tp vpn for win 10 users but ci...
May be I am over cautious , sorry to bug you here do I have to explicitly allow gateway as it is part of same pool. What a I understood that we are denying the traffic from his IPs to all vlan 200 network? lets say if gateway is .65, wouldn't it bl...
sure thanks, let me give it a try with Reload at command in case.And can you tell what is 99 here in this line below that you wrote earlier? Also in the wild card mask is different from earlier reply, is it deliberate?vlan access-map Vl200_host 99
