Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,I am looking for some advice on the best way to migrate from a single 5508 to a 5520 (I know this is an old bit of kit but it's only temporary solution to enable us to replace a number of AP's before migrating again to a newer WLC)We h...
Hello, I have recently rolled our some 2960-X switches where we replaced the 'config.text' file on the flash of the switch we were replacing it with. However, I have come to do the same with a Catalyst 3650 and the switch doesn't take the configurati...
Hello,
Hoping you can help please. I'm having issues with passing traffic through a Cisco ASA 5525-x when in transparent mode.
The Transparent mode firewall has been placed in between a layer 3 switch and another ASA running in routed mode, they ...
thanks for the suggestion, I've copied the running config to startup but i'm not sure where exactly on the flash the configuration file is stored ?? test-sw#copy running-config startup-configDestination filename [startup-config]?Building configuratio...
Thank you for your suggestions.
The issue turned out to be that the BVI interface not having any IP address within the subnet in which it was filtering traffic. As we were using the physical management interface to administer the device, I didn't t...