Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have a bunch of public IP addresses, on our PIX 525, which we have statically mapped to internal hosts (one by one) using the following command:static (inside,outside) 210.XXX.XXX.XXX 10.2.10.10 netmask 255.255.255.255 0 0We then use rules in a...
Hi All,We have a Cisco 3640 router which is now spare. It has two Ethernet interfaces physically.I would like to find out if we can configure this device for use as a VPN gateway to our network.We have a PIX firewall acting as a gateway for the netwo...
Hi,I have a series of sites with Cisco 800 series routers to connect to head office.These routers assign DHCP to the small number of clients in each location. We have begun a rollout of desktop management software which can also do PXE booting to ima...
Hi All,I would like to find out if there is some way our sattelite sites can register with Microsoft's AD integrated DNS services when the clients at this location use DHCP delivered by a Cisco 800 series router.Is there some sort of helper address o...
Hi all,I have a Cisco 827 at home I am using for a DSL gateway/firewall. I have a single dynamic IP and private hosts on the LAN side.So far, the connection is working, NAT is working, and port redirection (from the net to inside private hosts) is wo...
Hi VJ,Thanks again for your help and input (and to everyone who responded).Indeed, the client and server can ping each other from their respective subnets, so I dont see a routing issue interfering.One thought that has just occured to me is that our ...
Yes, the branch office router is configured with a DHCP scope for the clients in that office.The router also contains an ip helper-address on the Ethernet interface (where the DHCP clients are located).Do we need to put something in the DHCP scope in...
Hi VJ,The DHCP is controlled by our in office router at that site, but the boot image server is located in the head office across a WAN link, which the DHCP router connects to.We do not want centralized DHCP because if the link goes down then the rem...
Hi,I just got home and tried this, but no success.. none of the accounting commands worked for the ACL either, so I am not sure whats going on.I changed the access list as follows:access-list 111 permit tcp any host 192.168.0.20 eq ftpaccess-list 111...
I will certainly give that a try and see what happens. FTP was just a test to see if the ports were getting through to the inside.. I can see that it was probably a bad example since it uses so many ports.I will try the ACL accounting and see if that...
