hi,For a backup you are better to do this (on unix shell):# ls -la /opt/CiscoMGC/etc/active_link/lrwxrwxrwx 1 mgcusr mgcgrp 44 Nov 02 15:00 /opt/CiscoMGC/etc/active_link/ -> /opt/CiscoMGC/etc/CONFIG_LIB/CFG_config1This shows you where to f...

i do it the same and it's working fine.don't forget snmp configuration on your AS. this should do it:snmp-server view XXX cpmDS1ActiveDS0s included./regards

Hi,it sounds like you have configured pri-groups with NFAS on your controllers... like this:controller E1 1/0 pri-group timeslots 1-31 nfas_d primary nfas_int 0 nfas_group 0 service mgcp[...]In this case the D-Chan from the primary NFAS is automatica...

hi,for SS7 messages on PGW:cisco provides the 'snooper' trace tool and 'Packet Telephony Center - Monitoring and Troubleshooting' (PTC-MT)have a look at this for PTC-MThttp://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/ptc_mt/index.htmFor snoope...

Hi,for ITP (IP Transfer Point) you can use a C2651. have a look at this:http://www.cisco.com/en/US/products/sw/wirelssw/ps1862/index.htmladditionally the book 'Signaling system no. 7' (Lee Dryburgh) is a very good reference.http://www.amazon.com/exec...