cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

How can I get ss7 message (IAM / ACM/RLS...) on PGW2200

177telecom
Beginner
Beginner

1- anybody know how can i get ss7 message on PGW2200 . I don't know we can get it OR not on PGW . PLS help me .

2- My partner sent to my network the codec G729r8 pre-eitf . But in my AS5400 can not add this codec (IOS 12.3.10 have no support this command) .---> this call have disconnect cause 1F --> have anyway to fix it ?

Thank alot

2 REPLIES 2

amritpatek
Frequent Contributor
Frequent Contributor

1. Not sure if this is useful. You might like to have a look at the following document.

Cisco PGW 2200 Softswitch - Cause Code Modification

http://www.cisco.com/en/US/partner/products/hw/vcallcon/ps2152/products_tech_note09186a00801ffb61.shtml

2. For the 2nd question, it would be fine, if you would upgrade the IOS to support the required codec.

s.staege
Beginner
Beginner

hi,

for SS7 messages on PGW:

cisco provides the 'snooper' trace tool and 'Packet Telephony Center - Monitoring and Troubleshooting' (PTC-MT)

have a look at this for PTC-MT

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/ptc_mt/index.htm

For snooper trace tool request at TAC.

I didn't check out PTC-MT functionality by myself yet, but it looks quite interesting. Snooper is a very easy to use sniffer simmilar to tcpdump (in earlier versions it worked on top of tcpdump it think...).

regards

stephan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: