Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have 3 x SG300-52 in my network and I need make VLANs. In example VLAN10 on switch 1 and 3. How can I do connect switch 1>2 and 2>3 if on switch 2 there is no VLAN10? From router to switch1 I have port interface general tagged, i.e. port GE5 Ac...
@mridsing wrote:...
--------------
it would be better to go for trunk mode initially.
...
Hi, can You explain where should I set trunk? On every ports that connect R >< Sw1 >< Sw2 >< Sw3 ? Or only on R > Sw1?
Thank You, regards.
So I must to create VLAN10 on SW2? And what kind of interface I have to set? General, Trunk on thats every port connected every switches? In documentation I see that: "You can create a VLAN, but this has no effect until the VLAN is attached to at lea...
