Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Thanks for your post.
Yes SRW2024 SG300 series switch supports LAG.
you can check with the SG300 series datasheet:-
https://www.cisco.com/c/en_in/products/collateral/switches/small-business-smart-switches/data_sheet_c78-610061.html
Thanks...
Hi,
Thanks for your post.
Kindly request you to perform the following troubleshooting:-
-> Check with command prompt whether able to reach router's IP address
-> In case no access like destination host unreachable ,then will have to check with ad...
Hi,
Thanks for your post.
Yes you can jump to latest one signed and swipe image, then reboot switch so that new firmware can be active.
As for switch doesn't have feature of individually rebooting switches in stack (Manual from GUI or CLI).
Tha...
Hi,
Thanks for your post.
In case no configuration file was saved , then will have to reconfigure everything from scratch.
In case you require assistance in re configuring from scratch, you can call our frontline team and get a service request op...
Hi,
Thanks for your post.
Yes you can disable/Enable remote management in Rv34x. And still get an access to Rv340 from LAN connected port.
As for now we do not have CLI access available in Rv34x.
Thanks and regards,
Mridul
SBSC
