Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I created two SVIs, vlan 10 with 192.168.10.1 and vlan 20 with 192.168.20.1In my layer 3 switch, I assigned vlan 10 and vlan 20 to fa0/11 and fa0/23 respectivtly. as switchport mode access.I also enabled ip routing. In my PC, entered the stat...
Hi,I just bought used layer 2 and layer 3 switche to practice my ccna. But it prompted me to enter username and password which I do not have.Can anyone guide me on how to factory reset that device? Please, appreciate your help!Thanks,Fyaz
Hi,I have trunked 3 vlans from layer 2 switch to Layer 3. In order for all this 3 vlans to have internet, may I know how I should link the layer 3 switch with router? Does that mean, one port I will allocate to the LAN port of the router and another ...
Hi all,I created 2 different VLANS(vlan 30 and vlan 40) on a layer 3 switch. Layer 3 is being connected to the router via trunk port. Allowed vlan 30 and vlan 40.I have enabled dot1q command on my router for both this vlans defining the default gate...
Thanks mate! Can you please give me an example of layer 3 to layer 3 router configuration?Lets say my trunk port,from layer 2 switch fa0/24 is connected to layer 3 switch fa0/1. and I want to give the uplink to the router from layer 3 switch, from fa...
Hi Georg,I have not done any configurations yet. this is a doubt which I was having. Lets say my layer 3 switch have a trunk port from layer 2 switch. How can I uplink this to the LAN port of the router? Can I just directly connect a cat6 cable from ...
