Hi,
Need a little help with a route pattern if I may.
Some info:
CUCM 11.5.1
No transaltion patterns
All patterns below are in the same partition
We have the following route pattern for calls when dialing full 10 digits with area codes 02, 03, 07...
Hi all,I hope this isn't doubling up somewhere. A few minutes ago I posted a discussion but after clicking the Post Discussion button my post wasn't posted!I have a site with two switches; a CE520 and a C2960.The switches have two trunks between the...
Hi all,I have a site which has two switches; a CE520 and a C2960.There are two trunks between the two switches.one trunk with a native vlan 100 at both ends (voice vlan)the other trunk has native vlan 1 on the ce520 and 100 on the 2960; this is gener...
@Aeby Vinod wrote:I have a hunch the issue is that you don't have a dial peer defined for this pattern (unless you are using MGCP) , If its H.323 or SIP please attach the output of show run from the gateway here. Also please paste in the entire DNA r...
Thanks for the responses.
I should clarify that we need to dial a zero for an outside line and we have Discard Digits set to Predot.
I have run the DNA and here are some of the results.
------------------------------------------------------------...