Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
That problem has been mentioned couple of times but couldn't find an answer
My config:
aaa-server IAS_Internal_LDA protocol ldap reactivation-mode depletion deadtime 5aaa-server IAS_Internal_LDA (inside) host 10.0.10.162 ldap-base-dn DC=xxx...
Hi,
I have got ASA 5520, was previously set-up
When trying to connect via the console cable, asa keeps asking for username and password no matter what you type in
Does it mean the console access hasn't been set-up?
I can see all logs during booting ...
Hi All,
I have a problem with setting up static mapping on 5525 with the latest software,
Configuration attached.
Briefly, that has been implemented on ASA5525
object network sqldr
host 192.168.10.205
access-list acl_out extended permit tcp any obje...
Hi All,I have recently set-up a redundant link on our ASA, part of the config below:interface GigabitEthernet0/0 (Primary ISP) nameif outside security-level 0 ip address A.A.A.A 255.255.255.240 standby x.x.x.x!interface GigabitEthernet0/1 nameif insi...
Hi All,We have a layer 3 switch (.64.250) that has got two ASAs connected to it,1st ASA (.64.254) - it is default gateway 0.0.0.0. 0.0.0.0 for that layer 3 switch2nd ASA (.64.1) - 2nd gatewayAll are in the same subnetDHCP server assigns IPs to the co...
Great, thank you
All working as expected, there is no response on port 1433 because nothing is using it
Creating allow access list for rdp 3389 works like a charm
Thank you for your help !!!
Hi Karsten,
Thank you for that, my results below:
I used my external ip: 119.158.174.195 (laptop at home)
FW-DR# packet-tracer input outside tcp 119.158.174.195 1433 158.69.20.23 1433
Phase: 1Type: ACCESS-LISTSubtype:Result: ALLOWConfig:Implicit Rule...
Hi Karsten,
That works like a charm,
Server now is getting public it as wanted,
However, telnet connection from outside on port 1433 is still failing,
As before I can see hits in access-list,
access-list acl_out extended permit tcp any object sqldr ...
Hi,I think I should change the commands so they will reflect DR interface not outside oneHave just done that so the sh run icmp is below:icmp unreachable rate-limit 1 burst-size 1icmp permit any echo-reply DRBut anyway the above is inlcuded in the be...
