Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I connect to my Anyconnect client I get DNS 8.8.8.8 from my VPN client and it over right my local DNS on my PC. How do configure ASA so my VPN client DNS still my local PC DNS.
I am having issue with my site-to-site vpn tunnel with F5 configuration.Corporate Site Vendor siteASA5500 (VPN-Tunnel) <=========> F5 <========> internet <======...
I have two ssl vpn profile, can I restricts user to access only one ssl vpn profile when they get the ssl vpn service page. Each profile I create different type of access and they will get different client IP address.
Hi,I enable port-security on 4500 switch, I am running Version 12.2(25)EWA. I like to find out if I can configure my switch following way:PC1 is connect to the switch and working fine, if some one connect PC2, it disable the port. Normally, I need to...
With your help I am able to find the answer. username cisco password ciscousername cisco attributes service-type remote-access group-policy VPN_Inside attributes group-lock value VPN_InsideThank you all.
I already done with the basic configuration such as assigning IP, subnet and gateway. I can access all the device via http. I like find out how to deployment the video. How to upload and give access to the users etc.
Thank you for the command, I tested this command and it work they way I wanted. Here are the command that I used:Switch#configure terminalSwitch(config)#interface gigabitethernet 2/28 Switch(config-if)#switchport mode access Switch(config-if)#switchp...
