I have a switch 3550 which is working fine usuing vlan1. My questions are these:1.- I want to leavethe vla1 to do maintenane on the switch ifself2.- create a vlan 2 with different ip segment 3.- I create avlane with diferent IPmy provblem is te canno...
CiscoView 6.1 shows me the initial figure of the 3550-24 switch but it does not display the Configuration window. The IE browser shows this:address..http://172.20.1.2/homepage.htm"The Page Cannot Be Found"Here is the version of the switch (s):IOS(tm)...
I have a router that gives me exit to the Internet and since about 4 days ago when I ran the command " sh proces " it's showing 59 % to 65 % when the norm has been 3% to 10 %.So there is a device or several of them that are causing too much traffic d...
I have this scenario:1.- building A where all file servers are working2.- building B there is a dept that only has 25 people and computers and printers but not servers.Note; both buildings are connected via T1 and two routers3.- servers are Novell 4...
I have this question: it is posible to "shadow - see-observe-know " a telnet session?I want to know who is telneting the routers an specially what they are doing. I have noticed some changes and even that they are not critical I did not learn them ...
To all of you:Sorry to be so late replying to your answers. I had a little bet of hard time but I finally made it.Every one of your answer was useful.Arvindchari, thanks a lot for your answer it help me tremendously.Right now the switch is working fi...
Hi nhabib1.-open different browser: no, it does not work 2.- do you have the html files on your switch? I do not know. How or where can I check this? Can I fix this?( new plug-in or something ?)3.- Is http server enable on the switch? YES4.- Is 172.2...
Thanks for your response. This is the access-list created and it is in effect:Access-list 120 Applied to Fast Ethernet0/0 to watch incoming trafficDeny tcp any any eq 135 logDeny udp any any eq 135 logDeny tcp any any eq 137 logDeny udp any any eq ne...
Thank you all for all the help given.I found a SAP access-list in ruoter A. I removed and then I could see the printers from side B and side B could see the printers from side A. I was not an expert in SAP filters but I am now.sorry because took so...
