About brendan_kearney

brendan_kearney · 12-23-2014

i am looking to connect a sg300-28 (as the secondary or non-root bridge) to a sg500-52, using Port-Channeling with LACP and 802.1q.i have configured the ports as trunk, the port-channel as trunk, and added several vlans to the trunk. no link shows u...

brendan_kearney · 12-07-2014

i attempted to update my switch to the newer boot code and firmware version, but the device is now in an infinite reboot loop, is unresponsive to the serial console connection, and will not reset to factory image when i press and hold the reset butto...

brendan_kearney · 12-23-2014

yes, i did follow those directions to create the LAGs, but that was not my problem. not sure why i had it set, but mdix was set to on for all ports on both switches, and that is why no link would establish.i think i mistook the "mdix on" directive t...

brendan_kearney · 12-08-2014

seems i am not out of the woods just yet... -- Unit Number 1 --------------------------------------12-Jan-2014 18:08:17 %Entity-I-SEND-ENT-CONF-CHANGE-TRAP: entity configuration change trap.12-Jan-2014 18:08:23 %MNG_DIAG-E-DIAGATINIT...

brendan_kearney · 12-08-2014

the included serial cable was the answer.i know IOS class devices use rollover cables. what is specific to the serial cable inlcuded with these devices? i want at least one more of them, and will have to label the one i have...

Member Since	‎12-07-2014 11:56 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	5

User Statistics

User Activity

connect sg300-28 to sg500-52

sg500-52 infinite reboot after upgrade

yes, i did follow those

seems i am not out of the

the included serial cable was