Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 4 x Cisco 3750X-48-T-L switches (2 Stacks).These stacks are used in a iSCSI SAN:- IOS is 12.2(55)SE5 (ipbasek9)- only one VLAN- standalone iSCSI SAN- 5 x DELL Equallogic storage boxes per stack- Hyper-V hosts- VMware ESX hostsFrom time to time...
Hi,I have a hierachical network design using VSS as core switch/router, redundant distribution switches and access switches with multiple VLANs.Details: - EIGRP (EIGRP stub on distribution switches) - Routed-Etherchannels (/31) between core a...
Hi,I have a WLC 4402 configured with two VLANs (Company and GuestNet).Now I need to block a client on the GuestNet VLAN only using its MAC address.The access to the company WLAN should still be permitted.What is the easiest way to configure this?Than...
hi,I have a 6500 VSS which is connected to a 3500 via L3 etherchannel.Config VSS:interface Port-channel122 no switchport ip address 172.27.1.122 255.255.255.254interface GigabitEthernet1/1/46 no switchport no ip address channel-group 122 mode desirab...
Flowcontrol is enabled on the server and active (Oper-Status ON).However, It shouldn't be needed since the switch has only 1g i/fs and the servers should be able to handle this amount of traffic easily.
First of all, thanks for your answers!@manisharora111The links are L2 trunks. I'm running Rapid-PVST which prevents loops.@giuslarAfter some further tests I think the problem is related to EIGRP having an equal cost link to the distribution switches....
