I know this is a stretch to ask here... however, I'm using a tool called SmokePing that utilizes CiscoRTTMonEchoICMP to have a target send an ICMP echo from a different source IP address to a target IP address.I notice that an ASR1000, 10.85.85.85, I...
I have a 7600 running 12.2(33)SRE1. I was wondering why mls nde export statistics aren't incrementing.I have the following configured:ip flow-export source Loopback3ip flow-export version 5ip flow-export destination 192.168.2.200 9995mls flow ip inte...
I was experimenting with OSPF Stub Router Advertisement in my lab. I have a 6500 running 12.2(33)SXI. I notice that I'm unable to configure both gracefull shutdown and a delay on startup while awaiting for BGP convergence.If I have:router ospf 100max...
Hi,I can't test this out, right now. I was hoping someone here knew the answer. :) I was wondering is there a significant performance impact of putting "ip nat inside" on a 6500 interface. Assume CEF is on. Is all non-nat/nat traffic over the interfa...
I've been tasked with bridging a remote office subnetwork over a cisco 871 through their ISP back to a Cisco 3725 at main campus. From the cisco 3725 it needs to bridge back to a bluesocket brand gateway to be routed. The requirement was that the blu...
Here is an example of manually running the above to the working 7200 and the non-working asr. I had to change an input of integer to ticks from the above first manual run... You can see the snmpset to 10.2.2.2 works and the one to the asr1000 doesn't...
I did set the mls nde sender version to match up with netflow, but the real resolution to this problem was an extra command that was needed. I have time-based sampling turned on globally and I'm running a version of 1.2(33)SR code above SRB. You hav...
Thank you for the sanity check. I don't administer the bluesockets.. We have a separate group. To get the bluesocket to work like that, do I need to run PBR on the routers between the remote office 871 and the bluesocket? How do I insure that traffic...
Thanks for the help. In addition to the above, I needed to go in and hand remove files in the objectvcsroot directory. I was then able to add it without getting any errors.Thank you for your help!!!
When I goto RME->Inventory->delete devicesI should delete it from there, but do I also delete it from the suspended state out of "import status"?Thanks,Danny
