Hello all,i got a request from our production to check if their connection point cisco WS-C4506-E is ATEX certified with galvanic separated output, because they need to connect devices located in Ex zone 2. I went through all Cisco datasheets related...
Hi all,
I need to move currently active chassis (switch 1) of our VSS so I wanted to force-switchover to swap their roles. Unfortunatelly after "redundancy force-switchover" the former active chassis did not come up properly. I saw it present in sh s...
Hi,
I need to move standby chassis of our 6500 VSS and I need to minimize impart to our running services. If I turn off Standby chassis will be there any downtime/outage or Active chassis will handle all traffic immediately? All other devices are con...
Hi Mark,today I tried again force-switchover and it was successful :-). There was probably really just some hung state process jammed etc. as you mentioned yesterday. Anyway thank you very much for your hints and support :-)Richard
my fault ... i had to run it directly on standby switch and not from the active oneRTR-sdby-sp#sh vslp lmp statusInstance #2: LMP Status Last operational Current packet Last Diag Time sinceInterface Failure state ...
Thank you Mark.
I just tried commands you posted and maybe there could be an issue. If i ran "sh vsl 1 lmp status" I got it is working properly with no failure, but for 2 it returned emply result :-/. I guess it is not correct result, right?
RTR#sh...
i will try it again tomorrow during a day and I will see. Maybe it was caused just by some strange circumstances. I also tried reload only the Switch 1 by "redundancy reload shelf 1" but it did not help. Maybe something was stuck on a Switch 2 which ...
nope. There is no crashfile anywhere :-/
It is quite strange, because when I issued force-switchover Switch 2 become active without any issue and after a while I was able to see also that Switch 1 booted up and become Standby as I needed. So VSL ha...
