Dears, I am about installing WLC 9800-L-F port-channel to 9500 switch but i read in the deployment guide that 10G/1G uplink not support port-channel as below Data port behavior:• The 10G/Multigigabit copper port (or 10G/1G fiber port) will be disable...
Dears, If I remove the Device on ISE , Is the reports such as Commands Accounting associated to that device deleted automatically ? and what if I re-add this device, is the reports return again ?Thanks and BR;
But as the data sheet below, there are two uplink fiber 10G/1G https://www.cisco.com/c/en/us/products/collateral/wireless/catalyst-9800-series-wireless-controllers/datasheet-c78-742434.html
