05-26-2020 05:02 AM - edited 07-05-2021 12:05 PM
Dears,
I am about installing WLC 9800-L-F port-channel to 9500 switch but i read in the deployment guide that 10G/1G uplink not support port-channel as below
Data port behavior:
• The 10G/Multigigabit copper port (or 10G/1G fiber port) will be disabled if link aggregation (LAG) is
enabled – only 4x 2.5G/1G ports can be used for link aggregation.
My question, is it true that i won't be able to do LAG on the 10G Fiber, and if i want to do that must use the other ports 4x 2.5G/1G ports
Thanks and BR;
Solved! Go to Solution.
05-26-2020 04:13 PM
05-26-2020 07:54 AM
05-27-2020 01:38 AM - edited 05-27-2020 01:39 AM
But as the data sheet below, there are two uplink fiber 10G/1G
05-26-2020 01:04 PM
I'm in the same boat. I don't seem to see any mention of that on the guide you sent. Is this still the case?
05-26-2020 04:13 PM
05-26-2020 04:23 PM
05-27-2020 01:49 AM
Thanks
05-27-2020 01:48 AM
the document has been updated
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide