Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using a C8000v (17.9.1). In a nutshell, I have two VRF: one with OSPFv2 neighbors, one with OSPFv3 neighbors. OSPF peering are confirmed with CLI outputs : RT-20#show ip ospf neighbor
Neighbor ID Pri State Dead Time Addres...
Hello,
I have been trying to get the following rpc command to work without success:
<?xml version="1.0" encoding="UTF-8"?>
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="101">
<establish-subscription xmlns="urn:ietf:params:xml:n...
Hello,
Would it be possible to have up to date stencils for the Catalyst 8000 series? I think this is becoming quite important, especially since the ISR4000 are now becoming depreceated.
I have seen the one available on Products - Visio Stencils - Ci...
Hello,
I am trying to play a little bit with the CUCM certificate management API (Developer Support - UC Certificate Management API - Document - Cisco DevNet) but regardless of the API call, I always get 404 - not found response from the CUCM.
Fo...
Hi, thanks for this answer @Marcel Zehnder. I can indeed get the information this way. I would very much prefer using standard models though. I understand that native models are sometimes needed to represent specific features or implementations but O...
Hi,
Indeed, I'm currently doing it over the CLI but it's sort of limited.
Thanks for the support and for mentionning the note, I did not see it when I looked at the documentation
