Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I'm new to BGP multihoming and need some direction on the proper setup. I have acquired a /24 IP block from ARIN as well as a AS number. I have two ISPs and two routers that I will be using for this setup. I have gone through a number of docume...
I'm new to the dual sup setup so please bare with me on this. I have a 4510R+E with dual SUP8E cards. I have the redundancy mode set to SSO and the second sup8E is showing up in standby hot status. My question is, what is the best practice for cablin...
Hello,I have a scenario where I have multiple print servers on my outside interface that need to print/communicate to printers on my inside interface. I have setup a 1 to 1 nat for the printers but need to figure out the ACl for it. My thought was to...
HelloI'm new to ASA configurations and needing some help with a configuration on a 5555-X running 8.6 code. I need to allow multiple network ip ranges from my inside network to multiple subnets on the outside so that the outside systems only see inco...
I'm researching a problem we are experiencing with our iPads and Cisco AnyConnect Secure Mobility Client for the iPad. We have the On-Demand VPN feature turned on and it will start a vpn connection from within the Jabber app (although it can be inter...
Thank you. since I only have 1 /24 from ARIN, others have commented and suggested that would be a very risky thing and could very well become a transit for the internet which is something I do not want to be. I'm not a ISP just a smb organizatio...
Thank you. My goal is to NOT be a transit for the internet and I only have 1 /24 ARIN IP block. I do not have a /19 that I've seen in other examples. In some documentation I came across it said to advertise the iBGP in the dual router configuration. ...
