About alex.blaeuer

alex.blaeuer · 05-25-2023

‎10-15-2022 11:08 PMI am using a C9300-48UXM (IOS XE 17.06.04) to power a C9200CX-12T-2X2G (17.09.01). But the C9200CX is not drawing any power from it. Also when I am using the auxiliary power supply to power it up, the port the C9300 comes up and t...

alex.blaeuer · 10-24-2022

I am experiencing timeouts on one of the two configured RADIUS servers. When trying to trace the packets with packet-trace on the router, I see that a answer is received, but is getting drop.Conditions:! IPv4 Source IP 10.8.1.12 (RADIUS server with t...

alex.blaeuer · 10-15-2022

I am using a C9300-48UXM (IOS XE 17.03.04) to power a C3560CX-8PT (IOS 15.2(7)E3). Based on the Data Sheet, the C3560CX-8PT should be able to operate with a minimum of 2x PoE Uplink or 1x PoE+ Uplink. When I use 2x Uplinks, the switch can boot normal...

alex.blaeuer · 05-28-2023

Yes. As peer datasheet, the C9200CX-12T-2X2G should be able to be powered by 802.3bt class 6 PoE. In my understanding, this is UPOE (60W).The C9300-48UXM should be able to deliver this power.

alex.blaeuer · 10-24-2022

Hi Georg,Thanks for the reply. I put the output in the attachment.Best regards,Alex

alex.blaeuer · 10-17-2022

Hi Antonin,This command did the magic. The C3560CX-8PT gets now PoE+ over a single Uplink at the beginning of the boot process.Thank you very much.Best regards,Alex

alex.blaeuer · 10-15-2022

I have read this article. As I understand it, 2x UPoE uplink is the maximum supported for PoE base on the "Table 1. PoE Budget".>...The switch will enable powering over PoE, PoE+ and UPOE, as well as AC and DC input.

Member Since	‎04-03-2018 06:12 AM
Date Last Visited	‎06-15-2023 06:50 AM
Posts	7

User Statistics

User Activity

Powering C9200CX-12T-2X2G via UPOE

Radius timeouts on ASR 9906

Powering C3560CX-8PT-S via PoE

Re: Powering C9200CX-12T-2X2G via UPOE

Re: Radius timeouts on ASR 9906

Re: Powering C3560CX-8PT-S via PoE

Re: Powering C3560CX-8PT-S via PoE