Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks,
Quick question. I have purchased DNA Advantage licenses for Cisco SD-Access deployment. With SD-Access, we already have ISE 3.x Essential licenses. The question is do I also need to purchase ISE Advantage license? As mentioned on Cisco...
Hello Experts,
DNAC version : 2.2.3.6
ISE version: 3.1.0.518 patch 3
Devices are successfully LAN automating via the Border/CP Collocated nodes as the seed and peer devices.
Issue I am running with is some of the devices are not added as Network devi...
Hello Folks,
I wanted to understand if the Layer 2 Virtual Network Feature is supported for general deployments of SDA since the L2VN tab in DNAC still says to consult Cisco before proceeding. I have a scenario where the gateway sits outside the fabr...
Hello all,
DNAC integration with ISE giving error of "Error retrieving PSN nodes from PAN" in the discovering nodes state during integration. All pre-requisites of same GUI and CLI admin credentials on ISE are met including FQDN, reachability, etc. W...
Hi,
I am trying to use LAN automation from DNAC 2.2.3.5 and discover the devices connected to my seed and peer seed devices. The IS-IS config and other necessary part is done for seed and peer-seed but for the downlink connection to the PnP agent d...
I upgraded to 2.3.3.6 and I got to know that in version 2.2.3.x , it was limited but now I am happy to see the fully stabilised version in 2.3.3.6 and later. Thanks for your help!
Thanks for the information. One additional thing to ask regarding the L2VN-> which option would be suitable in a situation where the external L3 switch has the SVI and I want to connect that switch to the Border Nodes of the Fabric. I cannot use L3 H...
The integration is ACTIVE and when I added another fresh new switch, it got added right after LAN automation. I suspect something wrong in the 2 switches or I also suspect is because I LAN automated and deleted the 2 switches too many times for testi...
This device is supported but still stuck in the same process where 4500-X is stuck in error state when checked in DNAC GUI PnP menu. Also, TAC provided relevant commands equivalent to "pnpa service reset" along with deletion of crypto trustpoint was ...
Do you mean not supported for LAN automation? Because 4500-x are supported for SDA and I am trying to use it as Intermediate nodes. For 9300, it is working for me now and I had something wrong with the routing but its fixed now.
