Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to simulate an E1 with 2 2561 routers. I made a cross over cable 1-4 and 2-5 and tested fine with cable tester. I can't seem to get the interface to come up. controller is down and serial is in reset state.cards in both routers has an ...
The carrier setup a frame relay circuit with same DLCI numbers at both ends. Can the DLCI numbers be the same? The carrier claims since it is locally assigned it can be.
Does anyone know what is the difference between RS-530 and RS-530A beside the fact that RS-530A is the new standard? Where would I use one vs. the other?Thanks
I added the network-clock participate wic 0 to both routers but it did not help.I am assuming your crossover map:1-42-54-15-2The cable tested fine with the tester. I made a loopback cable and it works. When I use the loopback cable I get CD and bot...
The bandwidth setting has nothing to do with your throughput. your clockrate 64000 on your WAN router is setting your bps to 64k. Try changing your clockrate.Ramzi.
