Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem with PEAP-MSCHAPV2 authentication in combination with Wireless Service Module en Cisco ACS 4.1(and later i tested with IAS). When i use the Windows Supplicant i can get no connection with my wireless network, when i used the Intel...
I use Cisco ACS 3.3 version. When i want to configure RDBMS Synchronization i can't see the table "FTP Setup Options". I needed this table to configure FTP with the purpose of adding some user options. Somebody knows the solution for this problem ?
hi everbody,I have a problem. We use Ciscoview 5.5 and Ciscoworks 5.5. The problem is that ciscoview cannot change vlan of a catalyst 4500. The fiels were you can change the vlan is gray. I have updated the new packages and the fiels is still gray.Ca...
Hi,I have the same problem. But i can only select WPA or WPA2 in the WPA1+WPA2 section. Only WPA or WPA2 is not available in the layer 2 security. You have any solution at the moment or which version of the WISM you have?Thanks.
