Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I've got a Cisco Air AP1131 AG, and I have set it up through the web, using the links "Express set-up" and "Express security". I have configured to just use WEP.I only can connect with a laptop, no one more. And it is not a limit of one host, beca...
Hi. I don't know very much about configuration of Cisco routers.I have done "show run" and I see "interface Ethernet0" where the local ip of the router is set and I see "interface FastEthernet1", "interface FastEthernet2", "interface FastEthernet3", ...
Hi, thanks for the answers.Well, I have this configuration:interface Ethernet0 ip address 199.168.1.1 255.255.255.0 secondary ip address 192.168.2.1 255.255.255.0 secondary ip address 10.10.10.1 255.255.255.0 ip nat inside no ip mroute-cache!So, I ca...
Thank you very much.Well, the interface ethernet0 is not the wan interface. My configuration is this:interface ethernet0 ip address 192.168.1.1 255.255.255.0 interface ATM0.1 point-to-point ip address MYPUBLIC_IP_ADDRESSSo, the wan interface isn't th...
Thanks Scott.But I have not understood very well. My Cisco 800 is a DSL router, and it's the gateway for the office.So, I need to have an address for the ethernet0, don't I?A possible configuration would be this:interface ethernet0 ip address 192.168...
