Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,
Does GET VPN supports over Cisco SD-WAN ? Is there any alternate solution for GET VPN over the SD-WAN ? best practices document to GET Relationship to Tunnels ( SD-WAN ) ?
I am looking for AKIPS monitoring tool for cisco devices.
Given the requirements below I am concerned as to the load AKIPS may place on network devices.
Any idea on the load imposed by AKIPS ? Any Way to do impact assessment ? Any document ?
5000+ ...
Hi Team,
I am looking for some recommendation around 3750 and 4431 CPU or memory threshold value configuration.
Each month we have a few switches and routers that operate above the configured high tide values, almost every time the Team investigate t...
Hello,
I'm working on a deployment where we need to redirect wireless guests to a web portal for authentication. We're using CWA - the radius server sends a url-redirect to the NAD ( Meraki AP ) , as well as the url-redirect acl that is meant to spec...
Hi Everyone,
I have a question since I am deploying 802.1x port based security feature on CAT 29600 and following is the existing config with port-security enabled on the interface. Can I configure multi-auth for host mode on the interface ? ...
Hi Leo,
Thanks for your view on it.
Any impact assessment you did before you introduced or any load you can see on the network or any changes did you notice ?
Share any link or document you may have to go through.
Highly apricated
Hi leo,
Thanks for reply, 3750 is running 15.2 and I have following output
#sh processes cpu sortedCPU utilization for five seconds: 50%/1%; one minute: 58%; five minutes: 63%PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process185 1537677029...
Hi Joelm,
Thanks for your response :
yes, I can it is going around 20% in 3750-x
#sh processes cpu sortedCPU utilization for five seconds: 50%/1%; one minute: 58%; five minutes: 63%PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process185 153767...
Thanks Arne:)
It is annoying, I know.
I also found following issue while rebuilding the Node.
Application server went to running to not running to initializing state to running state
Any clue ?
ise24-fd1 logger: info:[application:operation:apps...
