Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I would like to know if it is possible to configure IKEv2 DVTI (dynamic VTI) between a ASA and an IOS router.The ASA would be the fixed-IP hub and the router would be the dynamic-IP spoke.I only found configuration examples with dynam...
Hello,I am trying to register a FPR1010 FTD (7.0.5) to FMC (7.2.1)- FMC is registered to Smart Licensing- registration over management interface- ping between FTD and FMC is successful- verified registration-key- with or without NAT-IDRegistration ti...
Hello all together,
I have now set up a little Test-Lab:Hub: ASA 9.20.(2)2 dyn. Spoke: IR829 15.9(3)M9IKEv2 SA and IPsec SA are established.IOS is routin into the tunnel because of static route pointing out tne tunnel interface.But ASA is not routin ...
Hello tvotna,Thanks for the article.The article describes the configuration on a FTD device with FMC.I am looking for a possibility to do that on a Cisco Secure Firewall with ASA image.On ASA image CLI, in the ‘tunnel-group XXXX ipsec-attributes’ con...
