Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys.
I'm trying to perform a POST Rest API toward Cisco DNAC (Catalyst Center).
The body it's like that:
[
{
"name": "Pool-1",
"type": "Generic",
"ipv4GlobalPool": "10.0.0.0/8",
"ipv4PrefixLength": 2...
Hello everyone.
We have deployed an 8000v as a transit control plane node.
We, therefore, created an SDA-Transit (named IV-Transit) and successfully assigned this SDA-Transit to one of the Fabric Site without any problems.
Subsequently, we created ...
Hello everybody.
I'm studying about multicast Tenant overlay flow in Cisco ACI.
I'm following this Case Study reference: https://www.cisco.com/c/en/us/support/docs/cloud-systems-management/application-policy-infrastructure-controller-apic/211631-Case...
Hello everybody. I would ask you a question regard Tunnel GRE from different VRF.For sure I missing some piece of the jigsaw. I created this simple topology on which I have two ptp connected router and two Tunnel GRE interface in a VRF-Lite: - VRF 2 ...
Hello Everybody. I would ask you regard this way to advertise a default route into EIGRP.I've read it on some blog: "Option #2The second method for injecting a default route into EIGRP is to configure a network command with 0.0.0.0. You must have the...
Thanks a lot for your reply.
Basically even if the multicast source streamer is directly connected to the FHR leaf, from ACI fabric perspective the multicast source steamer is behind the Spine/BL thanks to the vxlan encapsulation of multicast traffic...
Hello MHM Cisco World. Thanks for your reply.Your steps described the outgoing traffic from R2 perspective (Using my example topology).I understand it.My doubt it's regard the same packet arrived on R3.It's arrived on 192.168.23.3 interfaces (The tun...
Pman hello. First of all thanks your reply.I'm sorry but my question it's different: Suppose I configure: router eigrp 100network 10.1.1.0 0.0.0.255!ip route 10.1.1.0 255.255.255.0 ethernet0 Based on the article that I posted above:"You must have the...
Ciao Giuseppe! Thanks for asking, I hope you too!Yes the forwarding address it's 0.0.0.0 for both of them: R1# show ip ospf database external | i Link|Advertising|Forward|MetricType-5 AS External Link StatesLS Type: AS External LinkLink State ID: 10....
Helle Peter, Thanks a lot for the awesome explanation.It’s always a pleasure to read your content. My big mistake was to think about the flooding of the LSA-3I thank you for the time you have dedicated to me/us. I save it for my study paper Have you...
