Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We have installed ISE-PIC 2.7 which communicates with FMC. Recently i found out that the ISE is in version 3, but the ISE-PIC remains in version 2.7. Is there any roadmap for ISE-PIC to get on v3 or it will be replaced by ISE v3? I search ins...
Hello all,
I have a router that was configured with the following commands.
I need to give access for a specific host directly to Internet (plug and play)
Could you please tell me how to proceed and what else need to be configured?
Thank you in advan...
Hello all,
I am having a problem with a Cisco client switch ((C2950-I6Q4L2-M), Version 12.1(14)EA1a) that cannot receive updates from VTP server (WS-C3850-24XS).
You can see below both "show VTP status" commands:
Server Switch
VTP Version capabl...
Hi,
I want to install Technology Package 1.0.3 to Cisco Prime Infrastructure 1.3 to 3.0, but this requires the upgrade of the Prime to version 3.0.2. The binaries of this version doesn't exist inside Cisco Downloads site. is there any way to download...
Hello again,
I will try the latest configuration that you proposed with secondary IP address and check connectivity.
I need Internet access only so should i use any tcp protocol and other port in the below NAT statement?
ip nat inside source stat...
Hello Georg,
Thank you for your reply!
The host will be connected with a cable directly on the router.
All i need is a configuration to give the host Internet access.
So do i need to give the host the static IP 192.168.214.71, default gateway an...
Hello Paul,
Thank you for your immediate answer. Below you may find all configuration from router(except sensitive parts..
Based on the below configuration i need to give access to a host inside my Lan.
I don't mind if that host would be 192.168....
