Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!We have a root CA and wish to use CA-signed certificates in Cisco Works LMS. I cannot find in Cisco documentation how I can do that. Exactly:1. How CW can issue enrollment request?2. How CW can import CA-signed certificate?Can anybody help me?T...
Hello!I have a simple topology: two routers R1 and R2 connected to each other through ethernet link. Both routers runs OSPF. R1 runs OSPF process in the VRF 1. The ethernet link is configured for OSPF area 4. R2 also have loopback interface in area 0...
Hi there!Is there a way to set up a PPPoE client on a ethernet subinterface? (Cisco 1700 series)The problem is that there's no such command#pppoe-client.. in subinterface configuration mode.Is there any workaround?Thanks in advance!
Hello!I've configured IPSec VPN on my PIX (v.7.2.1) with certificate authentication. Sufficient lines of the config are posted below. VPN is initiated from the PIX side. When PIX tries to negotiate ISAKMP options to the peer, it doesn't send policies...
Hello!I have hub-and-spoke vpn network. The hub is a PIX with crypto map configuration. Now I'm adding new spoke device which is configured with VTI. Debug shows that IPSec cannot be established because of proxy address mismatch. Hub's crypto map acl...
Hello Mikhail!Thanks for your reply.The document you provided states that CEF doesn't load balance traffic on interfaces of different physical types. But I have interfaces of the same physical type: both serials. Will it load balance IP sessions as I...
Hello GNT,thanks for your valuable reply.I'll put my question in other way. Suppose a router has two EIGRP routes with costs of 1000 and 2000 respectively. Then I start 30 IP sessions all with different source/destination pairs. Does CEF distribute 2...
