Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi have a Catalyst 4500 with POE redundant power supplyes (PWR-C45-1300ACV). The only module supporting POE installed is a: WS-X4506-GB-T.I am not able to change the port power configuration, like if do not have access to the "power" command.I am run...
This is mostly a design question...I need to implement an open wireless access point for visitors who comes to our office for a few days or a few hours. i.e something simple to use for these people who are generally executives or clients and who do n...
On a Catalyst 4507R with redundant Sup. Engine IV, IOS 12.2.25EW PBR (Policy Based Routing) seems to not work correctly.Packets which should not be selected by the ACL are routed using the PBR policy. But they should routed using a static route.Here ...
I already tried. Looks like if the "power" command is not a valid command for the interface configuration:sw4500(config)#int gi 7/3sw4500(config-if)#power inline auto ^% Invalid input detected at '^' marker.module seven is my boar...
I asked myself the same question this morning. On my access point i found the following:4500-radio are HP Laptops with W500 wireless cards or Toshiba laptops with Intel 2200BG card with driver version 9.0.3.0.Toshiba Laptops with 2200BG card with ver...
I solved my problem by removing the policy from the vlan interface and re-applying it. It was not necessary to reboot the sup-engines.Thank you very much rick for help.Pascal
Rick,To answer your question:Yes, 10.230.10.1 and 10.230.10.5 are both routers. One to the internet link (default) the other is a frame router which is implemented for VoIP traffic to a remote link.10.220.59.16 0.0.0.15 is a small group of addresses ...
