11-21-2005 08:57 AM - edited 03-03-2019 12:52 AM
Hi have a Catalyst 4500 with POE redundant power supplyes (PWR-C45-1300ACV). The only module supporting POE installed is a: WS-X4506-GB-T.
I am not able to change the port power configuration, like if do not have access to the "power" command.
I am running 12.2(25)EW version of IOS.
Anybody have an idea of how to get power on one of these ports.
Thanks !
plepesant
11-21-2005 09:27 AM
Hi Friend,
Are you trying this on interface config mode.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet 4/1
Switch(config-if)# power inline auto
Switch(config-if)# end
Switch#
Check this link
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_25/cmdref/int_sess.htm
HTH
Ankur
11-21-2005 10:52 AM
I already tried. Looks like if the "power" command is not a valid command for the interface configuration:
sw4500(config)#int gi 7/3
sw4500(config-if)#power inline auto
^
% Invalid input detected at '^' marker.
module seven is my board supporting POE.
Pascal
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide