These other OIDs may be helpful as they can pull from VRFs as well. The following is an email to a client I pasted here:
The first OID I listed, 1.3.6.1.4.1.9.9.187.1.2.8.1.6
This one is called cbgpPeer2AdvertisedPrefixes and its description is:
"...
Hey Mark,
Flavio is correct in that you can issue the "upgrade hw-programmable cpld filename bootflash: <cpld.pkg> RP active" command. In your example above, put the ? after pkg (not R0) and you will see the option. However, this will not sol...
The main point is that a power-cycle is different from a reload. If you upgrade Rommon for example, the box will send a prompt something like "a RELOAD must be performed before the new Rommon will take effect". However, when you upgrade the CPLD, y...
Hi Mark. I have had extensive experience with CPLD upgrades, especially on ASR1Ks. In order for the new CPLD version to show up, the chassis must be power-cycled (power cables pulled, wait 10 seconds, and plug power cables back in). A reload will ...
As others have alluded to, for ASR1Ks, Netflow traffic is not allowed over Gig0. The BU determined that 1G would not be big enough, especially since this port is responsible for management purposes. For some reason, Gig0 can still be configured as ...
