Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need some help with a Pix config.I have a Pix with inside, outside and DMZ interfaces.I have a server in the DMZ, that I need to grant access to users from the inside network and from the Internet.As users inside and outside must use the same DN...
Hi,I'm trying to do an extended ping across an IP network. I want to be able to set the Type of Service of the packets to the same as that of our VoiP packets, which are tagged with DSCP EF.What Type of Service value should I use to achieve this.Als...
Hi.I have a problem where the best path to a particular destination is being withdrawn by BGP.To explain.Site A has 2 links to site B. 1 via an eBGP peer over MPLS, 2 via an iBGP peer over a VPN backup.I have configured the ebgp peer with a higher ...
Hi,I have 2 x 6506 switches that have a dual fibre trunk link between them.On the ports that make up the link, I am seeing a very high amount of giant packets.We are seeing an issue, where if 1 server is on switch A and another server is on switch B,...
Hi,I have 2 C6506 Switches and 1 C3662 Router. Topology is as followsC6506A dual connection to C6506 - BC6506B dual connection to C6506 - AC6506A single connection to C3662C6506B single connection to C3662On the 2 switches I have 4 or 5 VLANS, all...
Ok well, thanks for all your input. I went ahead and configured the Pix using the alias command to see if it would actually work.After doing some traces.Traffic is being natted to the correct address and being sent out the dmz interface.I am also s...
Hi,This is the command I am typing static (dmz,inside) public ip 10.66.106.2 netmask 255.255.255.255This is the error message.dmz 50 has a lower security value than inside 100ThanksLee
Hi,thanks for the tip, I tried using (dmz,inside) but it won't allow that as the inside interface has a higher security number than the dmz interface.I'll take a look at the alias command.ThanksLee
