Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Hopefully, this is the right forum to post this message. If not, I apologize.My setup:InternalFW: PIX515e(v6.3)VPN box: Connectra(Checkpoint)VPN box to be managed by the SmartCenter server(Checkpoint)I am trying to establish communication betwe...
Hello,I am trying to NAT one server IP situated on the inside interface on an 1841 router to an IP on each VLAN outside interface. Here's a sample of my router config:**************************************interface FastEthernet0/0 ip address 192.168....
Hello,We have two PIX515E(failover via serial cable). Ever since we physically relocated the two firewalls, it's been failing over to secondary then back to primary. It happened three times within a span of three months. I verified that there was no ...
Hello,We are currently using ISDN for our backup lines. I was asked if we can insert a special 6-digit number before dialing the 1+area code+number in the dialer string we would not have to pay a monthly requirement due to the new LD access code.I tr...
Greetings,I've been trying to look for anything relating to this over the Internet, but could not find anything. Is it possible to map MAC addresses to certain ports/interfaces on a PIX, if so, can someone please point me to the right direction?Thank...
Thanks David,This sheds a lot of light now on our design.Since I also could not get it to work thru a direct ACL(no NAT), I guess i have to either put the two boxes on the same segment or as you implied get e new firewall :-). I think this was a ques...
Hi Sushil,Thanks for your reply. I am passing TCP traffic over port 18191 between the two boxes.VPN traffic does not play a role yet in this situation as I am simply just trying to have one box on a DMZ communicate to another box on another DMZ for m...
How simple was that! A few switch ports that the PIX interfaces was plugged into was negotiating incorrectly(duh!). There was a huge amount of collisions/late collisions and deferred packet losses. So I just forced the duplex & speed on the switch p...
