Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am on Windows 10 Home Version 1903 I have installed SonicWall VPN (as a workaround) and Cisco VPN client.My VPN client shows "connected" a few secs after I start the vpn session VPN Client creates the following IP Interface on my WindowsEthernet ad...
I have two cisco catalyst 4948 and two servers with two ethernet boards each.
With these hardware at hand, what is my best shot at having a configuration in which the best redundancy scenario is achieved and I end up with only one IP that later can r...
Hi all,Right now I have a cisco router 1921 with GigabitEthernet0/0 as LAN interface and GigabitEthernet0/1 as WAN interfaceThis router has en expansion board with 4 additional interfaces. Is it possible to use one of these interfaces in the expansio...
Hi Guys,I have a Router 1921 connected to the internet and a few 2960 switches connected to this router over trunk interfaces.Is there an easy way to insert my ASA 5512x firewall into this configuration so that I dont have to change much of my config...
Hi,I am trying to NAT a service from the internet to an internal server IP and portmy Public IP is xxx.xxx.xxx.166 port 8181 and my private IP is the 192.168.3.150 port 8181 here is my config Current configuration : 2763 bytes!! Last configuration ch...
Hello SonicWall is only installed so that Cisco VPN Client works on Windows 10. It is a workaround.What I mean by "routing not working" is that even though the IP rule seems to be configured as shown in my original post, ping does not get routed to t...
hi Reza, thanks for the link.If I am not wrong, PBR is used in case you want to route traffic to a working WAN connection. If PBR detects the connection is down, it will only route traffic to the other WAN.What I need though is to route Internet traf...
ok, Reza. One router is fine for me for now.how should i configure my router in order to allow certain VLANs to use the 2nd WAN connection? my current router configuration is the following Current configuration : 3455 bytes!! Last configuration chang...
Hi Reza, I do have 2 WAN connections. My ISP provider has given me 2 different fiber optics cables, each with a different internet access. Justin, expansion board says "EHWIC-4ESG". Hope that means something...
Where to insert the ASA depends on which option is easier. Either before or after the router.I have 3 switches. the LAN interface of the router goes to Gi0/1 of my first switch with a trunk interface type. Gi0/48 interface goes to Gi0/1 of switch two...
