In a 3640, I issue the "show ip route" command.the following lines show up:C 192.168.91.0/24 is directly connected, Ethernet0/0S* 0.0.0.0/0 [200/0] via 192.168.91.205I'm trying to get rid of the directly connected route.I've issued the "no ip ro...
I'm trying to implement NAT for privates: 192.168.91.4 and 192.168.91.43why is it that the command: show ip nat translations verbose | include 192.168.91.4 shows up the following?:i include only a fragment:RT_DST001#show ip nat translations verbose |...
Is there a way to set up a 3640 to use a GPRS router within the same network segment in case the Ethernet link falls down?This is the actual scenario:192.168.1.206 router to set up. Cisco 3640192.168.1.205 this one has an Inet connection: Cisco 837 1...
Thank you much Rick.I was missing something.It's not the static route that I wanted to get rid of, but the directly connected one, though. Obviously, as by your response, I was wrong in expecting the directly connected route not to show in the routi...
thank you -Bo.I guess that's just the answer I was looking for.you mean that even if I didn't issue any specific command to announce that route, it's gonna be there, right?
What I meant is I need to implement NAT so private IP 192.168.91.43:443 can travel as 195.53.168.61:443To my understanding it is enough to go and:ip nat inside source static tcp 192.168.91.43 443 195.53.168.61 443which I have done already.The thing i...
Why don't you try to install a tftp server at a PC or laptop and download the router's IOS image there?http://www.winagents.com/downloads/tftpsetup.exeCisco IOS cannot be downloaded thru a console port.only to a flash card or tftp server.you can then...
Why don't you try to install a tftp server at a PC or laptop and download the router's IOS image there?http://www.winagents.com/downloads/tftpsetup.exeCisco IOS cannot be downloaded thru a console port.only to a flash card or tftp server.regards.
